Cleaning and Disinfecting Hardware

Cleaning and Disinfecting Hardware

Requirements

  1. Scrubbing Bubbles
  2. Non-abrasive scrub (Toothbrush recommended) 
  3. Paper towels or dry rag
  4. Protective gloves (optional)

Cleaning and Disinfecting Process

  1. Place the hardware in the sink or desired cleaning area.
    1. Make sure the area is clean before starting the process.
  2. Spray Scrubbing Bubbles on the hardware.
    1. Wait 1-2 minutes for the cleaner to loosen dirt and grime.
  3. Scrub the hardware with a non-abrasive brush until clean.
  4. Rinse the hardware off with low pressure water.
    1. Do not submerge the hardware in water.
    2. Do not use hot w
  5. Dry the hardware thoroughly with a paper towel or rag.
Do not attempt to charge any hardware unless it is completely dry.


    • Related Articles

    • ShadowCuff Cleaning Instructions

      It is essential to clean and maintain the ShadowCuff between each use to ensure the fiber optic cables continue to function properly. Both the fiber optic pins as well as the locking mechanism need to be cleaned between uses. Cleaning the ShadowCuff, ...

    • Hardware Dashboard

      A metric has been added to the Solutions Dashboard that displays the number of Active, Inventory, and Out of Service units for each hardware type. A filter at the top of the page allows users to view data by Parent Entity and its sub-entities. ...

    • Troubleshooting Hardware

      Introduction These steps should be taken and verified before any hardware is considered defective Prerequisites Before attempting to troubleshoot a hardware related issue, ensure that there is not any visible damage to the equipment in question. ...

    • Hardware Tab

      The Hardware tab within the enrollee profile will show all relevant information to any assigned hardware to the enrollee. Hardware can be assigned to an enrollee from this tab as well. To assign hardware from this tab refer to the article here ...

    • Assigning/Activating the ShadowTether Hardware

      Assign Hardware to an Inmate On the Inmate profile, select the Services>Device tab Select the Actions button>Assign Device Next, search by the Hardware ID number of the device you would like to assign to the inmate, double click to assign The device ...